Dragon Multi Guitar Stand

This section of our site is dedicated to woodworkers and DIY-ers that have built a project inspired by our outdoor plans and have sent us photos and a few comments about their woodworking endeavor.

We strongly encourage you to send us photos and your feedback regarding the projects on MyOutdoorPlans. Please send us the materials at [email protected] or using the contact form.

 

 

Dragon Multi Guitar Stand

Building-a-guitar-stand

 

DIY-Wood-Guitar-Stand

 

Side-of-the-guitar-stand

 

How-to-build-a-multi-guitar-stand

 

From Kevin, 

I used recycled Mahogany and planed to approximately 1/2 inch, I strengthened the design with glue blocks and corner braces. Designed the dragon to fit the side pieces and the wing is cut into the top corner brace. I used a scroll saw to cut out as well as to cut plastic to fit.

The plastic is a clear sheet and a red piece sandwich this allows the plastic to be approx 1/2 inch thick, this is glued into wood with clear glue. I cut leather 2 different size leather circles with hole saw, note only a partial cut with hole saw then a sisor cut to finish. I completed with danish oil. Thank you to my outdoor plans for the plans.

 

 

From Plans: http://myoutdoorplans.com/stand/wooden-guitar-stand-plans/

Difficulty Level: easy

Time Required: 1 day

Total Cost: –

 




2 Comments

  1. Julian
  2. Tom Fleck

Reply Cancel Reply

error: Content is protected !!