333
DIYÂ Small Entryway Bench
From Bren,
This was a neat little project that only took me a few hours and cost about $25 using pine hobby panel boards and 1 X 4 trim for the top as opposed to the 1 X 3 from the plan. We needed a small bench for our garage entrance and this fit the bill perfectly. As described by the other builder of this project I just screwed the dividers from the bottom since it was difficult to fit my drill in between the top and bottom to use pocket screws for both sides of the divider. For finish I just used three coats of Polycrylic, this stuff is easy to use and clean up, I love it.
Â
Â
EXPLORE MORE IDEAS FOR:
 |
 |
 |
 |
