10×12 Run in Shed Trims Plans

This step by step diy project is about 10×12 run in shed trims plans. This is PART 3 of the horse shed project, where I show you how to fit the kickboards and the decorative trims to the exterior of the structure. Take a look over the rest of my woodworking plans, if you want to get more building inspiration.

When buying the lumber, you should select the planks with great care, making sure they are straight and without any visible flaws (cracks, knots, twists, decay). Investing in cedar or other weather resistant lumber is a good idea. Use a spirit level to plumb and align the components, before inserting the galvanized screws, otherwise the project won’t have a symmetrical look. If you have all the materials and tools required for the project, you could get the job done in a few day. See all my Premium Plans HERE.



Projects made from these plans




10×12 Run in shed trims




[tabs tab1=”Materials” tab2=”Tools” tab3=”Time” tab4=”Related Plans”] [tab id=1]

  • – 51 pieces of 1×8 oak – 48″ long KICKBOARDS
  • K – 2 pieces of 1×4 lumber – 86 1/2″ long, 2 pieces – 94 1/2″ long, 2 pieces – 93″ long, 2 pieces – 85″ long TRIMS

  • 26 pieces of 1×8 oak – 8′
  • 8 pieces of 1×4 lumber – 8′
  • 2″ nails
  • wood filler , wood glue, stain/paint
  • anchor kit

[/tab] [tab id=2]

 Hammer, Tape measure, Framing square, Level

 Miter saw, Drill machinery, Screwdriver, Sander

 Safety Gloves, Safety Glasses

[/tab] [tab id=3]

 One day

[/tab][tab id=4]




Building trims for the 10×12 barn shed

Back kickboards

Back kickboards

Fit the 1×8 oak boards to the back interior of the run in shed. Cut the boards at 48″ and then secure them to the supports with 2″ nails.

Side kickboards

Side kickboards

Fit the 1×8 oak kickboards to the sides of the shed interior. Leave gaps between the boards and align them to the top supports. Insert 2″ nails to secure the boards to the supports.

Fitting the side trims

Fitting the side trims

Use 1×4 lumber for the side trims. Use a saw to cut the trims at the right size and angle and then secure them to the sides of the shed. Use 2″ nails to secure the trims to the shed.

Front trims

Front trims

Fit the 1×4 trims to the front of the shed, as well. Align the edges and use 2″ nails.

Back wall trims

Back wall trims

Fit the trims to the back of the 10×12 run in shed. Align the edges with attention and insert 2″ nails to secure the trims into place.

10x12 Run in Shed Plans

10×12 Run in Shed Plans

Last but not least, you need take care of the finishing touches. Fill the holes with wood putty and then smooth the surface with 120-220 grit sandpaper. Apply a few coats of paint or stain to the components, so you can protect them from decay and so you can enhance the look of the shelter. Check out PART 1 and PART 2 of the shed, so you can learn everything you need to know about building the walls and roof for the shed.



This woodworking project was about 10×12 run in shed trims plans. If you want to see more outdoor plans, check out the rest of our step by step projects and follow the instructions to obtain a professional result.




Leave a Reply

error: Content is protected !!